![]() Install with an appropriate fixing and add flat packers adjacent to the fixing positions to prevent distortion. Start at the bottom and drill one hole below the hinge.Corner fixings should be around 150mm from each corner, while holes should roughly measure 300-600mm apart. Take a high-speed drill bit, and add fixing holes into the sides of the frame.Open the door and check the level of the frame, and make sure it isn't bowed - this can cause a lot of problems further down the line!.Make sure the frame is central, and the 5mm gap is maintained. Place the frame into the opening above the cill.Remove corner protectors and protection tape.Coat the end of the cill with silicone sealant. ![]() Slowly position and fix the cill into the frame.Apply to the raised area only, and watch out for drainage holes. Once level, remove and apply an all-purpose silicone sealant along the inner edges on the bottom of the rail frame.If something isn't right, use flat packers to adjust.Slowly place the cill into position, and then check the level with a spirit level.Fit the cill end gaps to the cill using super glue.Measure and cut the cill to match the width of the door opening - it can be straight cut or, in some circumstances, rebated to enhance any external brickwork. ![]() This will enable you to square the frame in the opening.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |